SCR#3

Make the Landing Gear:

1. Cut a piece of cardboard into a rectangle that is 3” wide by 5 ½” long. Make two of them.

2. Place a mark 1” in from the edge along the bottom.

3. Draw a line all the way across the rectangle 2 ½” up from the bottom edge.

4. Draw an angled line from the 1” mark to the end of the line at 2 ½” .

5. Cut the angled line.

6. Cut a slot from the straight edge along the line at the 2 ½” mark halfway across.

7. Trace it on the other rectangle to make two pieces.

Assembly of wings, landing gear, and fuselage:

1. Slide the landing gear into the slots on the bottom wing.